Sharp MX-M182D 사용자 설명서
46
3
TWO-SIDED COPYING USING THE
BYPASS TRAY
BYPASS TRAY
To perform manual two-sided copying, follow these steps.
Example: Copying originals A and B onto each side of one sheet of paper
1
Copy original A.
2
Place original B as shown below.
Vertically-oriented
original:
If the original is oriented
vertically, place it in the
same orientation as
original A.
original:
If the original is oriented
vertically, place it in the
same orientation as
original A.
Horizontally-oriented
original:
If the original is oriented
horizontally, place it with
the top and bottom and
left and right sides
reversed with respect to
the placement of original
A.
original:
If the original is oriented
horizontally, place it with
the top and bottom and
left and right sides
reversed with respect to
the placement of original
A.
3
Turn the copy of original A over, and
without changing the position of the
edge closest to you, insert it in the
bypass tray.
without changing the position of the
edge closest to you, insert it in the
bypass tray.
Insert the paper all the
way in.
way in.
4
Select the bypass tray with the
[PAPER SELECT] key, and then press
the [START] key (
[PAPER SELECT] key, and then press
the [START] key (
).
The copy is delivered to the paper output tray.
Original A
Original B
Copy
If you are using the MX-M182D/MX-M202D/
MX-M232D
The MX-M182D/MX-M202D/MX-M232D is equipped
standard with an automatic two-sided copying function
that automatically turns over the paper. If paper in
"Paper that can be used for automatic 2-sided printing
(MX-M182D/MX-M202D/MX-M232D)"
MX-M232D
The MX-M182D/MX-M202D/MX-M232D is equipped
standard with an automatic two-sided copying function
that automatically turns over the paper. If paper in
"Paper that can be used for automatic 2-sided printing
(MX-M182D/MX-M202D/MX-M232D)"
this enables easier two-sided copying than using the
bypass tray. See "AUTOMATIC TWO-SIDED COPYING
(MX-M182D/MX-M202D/MX-M232D)"
bypass tray. See "AUTOMATIC TWO-SIDED COPYING
(MX-M182D/MX-M202D/MX-M232D)"
1
1
Original A
Copy of
original A
original A
1
1
Original A
Copy of
original A
original A
2
Original B
2
Original B
• Copies made on the back side of paper
should always be made one sheet at a time
using the bypass tray.
using the bypass tray.
• Straighten curled or wavy paper before
using it. Curled paper may cause misfeeds,
creases, or a poor-quality image.
creases, or a poor-quality image.
• After placing the original, be sure to close the
document cover/SPF/RSPF. If left open,
parts outside of the original will be copied
black, causing excessive use of toner.
parts outside of the original will be copied
black, causing excessive use of toner.
2
1
1
Copy of
original A
original A
Original B
2
1
1
Copy of
original A
original A
Original B
Note