Grizzly G9749 사용자 설명서

-12-

G9749 Variable Speed Drill Press

The  Model  G9749  was  carefully  packed  when  it
left  our  warehouse.  If  you  discover  the  machine
is  damaged  after  you  have  signed  for  delivery,
please  immediately  call  Customer  Service  at
(570) 546-9663 for advice.

Save the containers and all packing materials for
possible inspection by the carrier or its agent.
Otherwise, filing a freight claim can be difficult.

When you are completely satisfied with the condi-
tion of your shipment, you should inventory the
contents.

Unpacking and

Lifting

The Model G9749 weighs 615 lbs. You will

need power lifting equipment and assistance

to remove this machine from the pallet and

position it. Inspect all lifting equipment and

make sure that all is in perfect working order

and is rated for the load before attempting

to lift and move this drill press. Ignoring this

warning may lead to serious personal injury

or death.

To unpack and move the drill press:

1. Read this entire SETUP section before

continuing. Pay special attention to

Site

Considerations on Page 11 and Mounting

to Shop Floor on Page 13.

2. Remove the sides and top of the shipping

crate.

3. Position the lifting straps under the headstock

as shown in

Figure 6. Make sure the straps

are not in contact with any controls, wires, or
handles.

Figure 6. Location of lifting straps.

4. Position lifting straps, your lifting device, and

your assistant to support the drill press in a
vertical and stable position.

5. Unbolt the drill press from the pallet.

6. Slowly raise the drill press from the pallet,

then carefully move the drill press to your
prepared location.

7. With the drill press securely resting on the

floor, shim between the floor and drill press
base as required to level the drill press
table.

8. Secure the drill press to the floor, but DO

NOT overtighten the fasteners.

9. Recheck the table to make sure that it is still

level, and re-shim as required.