Sharp AR-M205 사용자 설명서

The power switch is located on the left side of the machine.

It will take about 45 
seconds for the machine 
to warm up. While the 
machine is warming up, 
the POWER SAVE 
indicator will blink. (The 
POWER SAVE indicator 
will go off when the 
machine is ready to 
copy.)

However, you can make desired settings and press 
the [START] key (

) during warm-up. Copying will 

start after warm-up.

If the power switch is 
turned off while the 
machine is in operation, 
a misfeed may occur and 
the job that was in 
progress will be 
canceled.

Check the following to make sure the machine is not in 
operation:
• The START indicator is lit. (Initial state)
• The POWER SAVE indicator is lit. ("Preheat mode" 

or "Auto power shut-off" mode)

This function automatically switches the machine to a low power consumption state if the set duration of time 
elapses without the machine being used when the power is on. The POWER SAVE indicator lights up, however, the 
keys on the operation panel can be used. Normal operation automatically resumes when a key on the operation 
panel is pressed, an original is placed, a print job is received, or scanning is begun from a computer.

This function automatically switches the machine to a state that consumes even less power than preheat mode if the 
set duration of time elapses without the machine being used when the power is on. All lights except the POWER 
SAVE indicator and ON LINE indicator go off. To resume normal operation, press the [START] key (

). Normal 

operation also resumes automatically when a print job is received or scanning is begun from a computer. While in 
auto power shut-off mode, no keys (except the [START] key (

)) can be used.

• "Auto clear" is initially set to return the copy settings to the initial settings when the [CLEAR ALL] key (

) is 

pressed, and after one minute elapses after a copy job is finished. When "Auto clear" operates, all previous 
settings are cleared. The setting for "Auto clear" can be changed in the user programs. (p.44)

• The machine is initially set to automatically enter power save mode if not used for copying, printing, or scanning 

for a preset period of time. This setting can be changed in the user programs. (p.44)

The machine has two power save modes to reduce overall power consumption thereby 
reducing the cost of operation. In addition, these modes conserve natural resources and help 
reduce environmental pollution. The two power save modes are "Preheat mode" and "Auto 
power shut-off mode".

The preheat activation time and the "Auto power shut-off timer" can be changed using user programs. It is 
suggested that you set times that are appropriate for your usage of the machine. (p.44)

The machine assumes the initial settings when it is first turned on, when the [CLEAR ALL] key (

) is pressed, 

and approximately one minute after the last copy is made in any mode.
Copy ratio: 100%, Exposure: Automatic
Copy quantity: 0, All special copier modes: Off
Auto paper selection: On, Paper feed station: The tray selected in the "Default tray setting" in the user programs.(p.46)