Sharp AR-203E 사용자 설명서
52
MISFEED REMOVAL
When the misfeed (
) indicator blinks or
blinks in the display, the unit will
stop because of a misfeed. If a misfeed occurs when using the SPF, a number may
appear in the display after a minus sign. This indicates the number of the originals
that must be returned to the original feeder tray after a misfeed. Return the required
number of originals. Then this number will disappear when copying is resumed or the
clear (
appear in the display after a minus sign. This indicates the number of the originals
that must be returned to the original feeder tray after a misfeed. Return the required
number of originals. Then this number will disappear when copying is resumed or the
clear (
) key is pressed. When the SPF misfeeds an original sheet, the unit will
stop and the SPF misfeed (
) indicator will blink, while the misfeed (
) indicator
will remain off. For a misfeed of originals in the SPF, see "E: Misfeed in the SPF"
(p.55).
(p.55).
1
Open the multi-bypass tray, and side cover, in that order.
To open the multi-bypass tray, see "The multi-bypass tray" (p.10). To open
2
Check the misfeed location. Remove the misfed paper
following the instructions for each location in the illustration
below. If the misfeed (
following the instructions for each location in the illustration
below. If the misfeed (
) indicator blinks, proceed to "A:
If the unit is turned on with the lower side cover open, the misfeed (
)
indicator will blink. In this case, close the lower side cover. The misfeed
(
(
) indicator will go out.
If paper is misfed here, proceed to "A:
Misfeed in the paper feed area". (p.53)
Misfeed in the paper feed area". (p.53)
If paper is misfed here, proceed to "B:
Misfeed in the fusing area". (p.53)
Misfeed in the fusing area". (p.53)