Xerox 7232 사용자 설명서

Select [Port Settings].

Select [SMB], and then [Change Settings].

Select [Port Status] and [Change Settings].

Select [Enabled], and then [Save].

Next, establish TCP/IP if you use an IP address for your network environment.

In [Connectivity & Network Setup], select [Protocol Settings].

Select [Protocol Settings].

Under [TCP/IP - IP Mode], select [IPv4 Mode], [IPv6 Mode], or [Dual Stack].

Select [IP Address Resolution], and then [Change Settings].

Select a method for establishing an IP address from [DHCP], [BOOTP], [RARP], 
[DHCP/Autonet], and [STATIC], and then select [Save].

NOTE: Use the DHCP server together with the Windows Internet Name Server 
(WINS) server.

If you selected [STATIC] in step 5, then proceed to step 6 to configure the protocol 
settings. Otherwise, proceed to step 12.

Select [IPv4 - IP Address], and then [Change Settings].

Use the keypad on the screen to enter the IP Address for the machine in the 
format “xxx.xxx.xxx.xxx”. When you have finished entering all values, select 
[Save].

Select [IPv4 – Subnet Mask], and then [Change Settings].

Using the same method as in step 7, enter the Subnet Mask.

Select [IPv4 – Gateway Address], and then [Change Settings].

NOTE: If you do not wish to set the gateway address, leave this field blank.

Using the same method as in step 7, enter the Gateway Address.

Select [IPv4 – IP Filter], and then [Change Settings].

Select [Enabled] to filter access to the machine.

NOTE: If you do not wish to use the IP filter feature, select [Disabled].

NOTE: Use CentreWare Internet Services to register the IP addresses which are not 
allowed to access the machine. 

When you have finished establishing TCP/IP, select [Close] on the [Protocol 
Settings] screen.

Set [IPv6 Address Manual Configuration].