Toshiba 165 사용자 설명서
Preparation 1 - Turning Power ON 33
Preparation 1 - Turning Power ON
Turning power ON
1
Open the power switch cover, and then press the power switch to
“ ” (ON) side.
“ ” (ON) side.
The equipment starts warming itself up. The warm-up time takes approx. 25 seconds.
When the warm-up has finished, the equipment is ready for copying. “READY” appears
on the LCD screen.
When the warm-up has finished, the equipment is ready for copying. “READY” appears
on the LCD screen.
If you place an original and press the [START] button during the warm-up, copying auto-
matically starts when the warm-up has finished (= auto job start). When the job is
reserved, “Auto Start” appears on the LCD screen.
matically starts when the warm-up has finished (= auto job start). When the job is
reserved, “Auto Start” appears on the LCD screen.
2
The LCD screen below is shown if the equipment is managed under
the department code function. Key in the department code.
the department code function. Key in the department code.
Key in a 5-digit department code, and then press the [ENTER] button. Then the
equipment is ready for copying.
equipment is ready for copying.
If the department code function is enabled, press the [FUNCTION CLEAR] button after
any operation has been finished to prevent unauthorized use of the equipment.
For the details of the department code, see the following page:
any operation has been finished to prevent unauthorized use of the equipment.
For the details of the department code, see the following page:
Turning power OFF
Open the power switch cover, and then press the power switch to “
” (OFF) side.
READY
1
100%
NONSORT
ZOOM
FINISHING
EDIT
Enter DEPARTMENT CODE
1
100%
NONSORT
ZOOM
FINISHING
EDIT