Canon 5065 사용자 설명서

Specifying Common Settings

C

u

sto

m

iz

ing Settings

 

If a problem frequently occurs when using the Finishing modes, such as Offset 
Collate and Staple, you can temporarily limit the use of these finishing modes by 
setting Limited Functions Mode to 'On'.

In addition, when the Service Call Message screen appears indicating a finishing 
mode malfunction and you temporally set the Limited Functions Mode to clear the 
Service Call Message screen, you can deactivate the Limited Functions Mode by 
setting this mode to 'Off' from the Additional Functions screen. However, after the 
Limited Functions Mode is deactivated, the Service Call Message screen may 
appear again, unless the cause of the malfunction is cleared. (See "Setting the 
Limited Functions Mode from the Service Call Message Screen," on p. 8-100.)

NOTE

 

[Limited Functions Mode] is displayed only if an optional finisher is attached.

➞ [Common Settings] ➞ 

➞ press [OK].

NOTE

 

The Limited Functions Mode is enabled only after you restart the machine (the 
main power switch is turned OFF, and then back ON). For instructions on restarting 
(turning the main power switch OFF and then ON) the machine, see "Main Power 
and Control Panel Power," on p. 1-16.

 

You can set whether to force to output excess tab paper that was not used for a 
Copy or Print job that included tab taper. For more information on copying or 
printing on tab paper, see Chapter 4, "Special Copying and Mail Box Features," in 
the Copying and Mail Box Guide.

➞ [Common Settings] ➞ 

➞ press [OK].