IBM 201 사용자 설명서
Two short beeps
POST encountered an error. The Configuration/Setup Utility program will
display additional information; follow the instructions that appear on the
screen. See “POST error messages” on page 92 for descriptions of the text
messages that might appear.
display additional information; follow the instructions that appear on the
screen. See “POST error messages” on page 92 for descriptions of the text
messages that might appear.
Three short beeps
A system memory error has occurred. This combination occurs only if the
video Basic Input/Output System (BIOS) cannot display the error message.
Replace the failing memory module.
video Basic Input/Output System (BIOS) cannot display the error message.
Replace the failing memory module.
Repeating short beeps
The system board might contain a failing component, your keyboard might
be defective, or a key on the keyboard might be stuck. Ensure that:
1. Nothing is resting on the keyboard and pressing a key.
2. No key is stuck.
3. The keyboard cable is connected correctly to the keyboard and to the
be defective, or a key on the keyboard might be stuck. Ensure that:
1. Nothing is resting on the keyboard and pressing a key.
2. No key is stuck.
3. The keyboard cable is connected correctly to the keyboard and to the
correct connector on the appliance.
Running the diagnostic tests can isolate the appliance component that
failed, but you must have your system serviced. If the error message
remains, call for service.
failed, but you must have your system serviced. If the error message
remains, call for service.
Note: If you just connected a new mouse or other pointing device, turn off
the appliance and disconnect that device. Wait at least 5 seconds;
then, turn on the appliance. If the error message goes away, replace
the device.
then, turn on the appliance. If the error message goes away, replace
the device.
One long and one short beep
POST encountered an error on a video adapter. If you are using the
integrated video controller, call for service. If you are using an optional
video adapter, replace the failing video adapter.
integrated video controller, call for service. If you are using an optional
video adapter, replace the failing video adapter.
One long and two short beeps
A video I/O adapter ROM is not readable, or the video subsystem is
defective. If you hear this beep combination twice, both the system board
and an optional video adapter have failed the test. This beep combination
might also indicate that the system board contains a failing component.
defective. If you hear this beep combination twice, both the system board
and an optional video adapter have failed the test. This beep combination
might also indicate that the system board contains a failing component.
One long and three short beeps
This series of beeps has two meanings. The first means that the POST has
completed without detecting errors, when a monitor and keyboard is not
attached. However, when a monitor is attached, and you hear this series, it
means the system-board video subsystem has not detected a monitor
connection to the appliance. Ensure that the monitor is connected properly
to the appliance. If the problem persists, replace the monitor.
completed without detecting errors, when a monitor and keyboard is not
attached. However, when a monitor is attached, and you hear this series, it
means the system-board video subsystem has not detected a monitor
connection to the appliance. Ensure that the monitor is connected properly
to the appliance. If the problem persists, replace the monitor.
Two long and two short beeps
POST does not support the optional video adapter. This beep combination
occurs when you install a video adapter that is incompatible with your
appliance. Replace the optional video adapter with one that the appliance
supports or use the integrated video controller.
occurs when you install a video adapter that is incompatible with your
appliance. Replace the optional video adapter with one that the appliance
supports or use the integrated video controller.
Table 15 on page 89 describes the codes and specifies the action to take.
88
NAS 200 User’s Reference