Siemens KVM s2-0411 사용자 설명서
Canceling scan mode
Basic operations
32
590-595-609A
Figure 18: Commands window
Select Scan Enable in the Commands window. Scanning will be begin immediately.
Click X to close the Commands window.
3.9.4
Canceling scan mode
Complete one of the sollowing steps:
If the OSCAR interface is open, select a target device.
-or-
If the OSCAR interface is not open, move the mouse or press any key on the
keyboard to stop scanning at the currently selected target device.
keyboard to stop scanning at the currently selected target device.
3.10
Running switching system diagnostics
You can validate the integrity of the switching system through the Run Diagnostics
command. This command checks the main board functional sub-systems (memory,
communications, appliance control, and the video channels) for each system controller.
When you select the Run Diagnostics button, you will receive a warning that indicates
that all users (remote and local) will be disconnected. Click OK to confirm and begin the
test.
command. This command checks the main board functional sub-systems (memory,
communications, appliance control, and the video channels) for each system controller.
When you select the Run Diagnostics button, you will receive a warning that indicates
that all users (remote and local) will be disconnected. Click OK to confirm and begin the
test.
The Diagnostics window opens. The top section of the window opens the hardware
tests. The bottom portion divides the tested KVM-IAs into three categories: On-line,
Offline or Suspect. KVM-IAs might be listed as offline while being upgraded.
tests. The bottom portion divides the tested KVM-IAs into three categories: On-line,
Offline or Suspect. KVM-IAs might be listed as offline while being upgraded.