Sharp PNV600 사용자 설명서

ENGLISH

7

E

Caution

•  Turn on the monitor first before turning on the PC or

playback device.

Caution

•  The main power must be turned on/off with the main power

switch. Do not connect/disconnect the power cord or turn 

the breaker on/off while the main power switch is on.

•  When switching the main power switch or the POWER

button off and back on, always wait for at least 5 seconds.

•  For a complete electrical disconnection, pull out the main

plug.

Press the POWER button on the remote control unit or the

monitor itself to turn the power ON/OFF.

When the main power switch is off, the monitor cannot be

turned on using the POWER button on the remote control unit.

Lit green

Power on

Lit orange

Power off (Standby mode)

Flashing green

Input signal waiting mode

n

When the monitor is turned on for the first time after being

shipped from the factory, the operation mode setting screen 

will be displayed. Set it to MODE1 or MODE2.

MODE1 ....OFF IF NO OPERATION is set to ON, and 

STANDBY MODE is set to LOW POWER. (These

settings can not be changed.) 

If there is no operation for 4 hours or more, the 

monitor  automatically enters standby mode. Power 

consumption in standby mode is also minimized.

MODE2 ....Will perform standard operation. 

OFF IF NO OPERATION is set to OFF, and 

STANDBY MODE is set to STANDARD. These

settings can be changed.

Even after being set, changes can be made using 

OPERATION MODE, located in the menu of the monitor. (See 

Operation manual.)

n

•  If the time has yet to be set when the monitor is first turned on,

the date/time setting screen appears. Set the date and time.

/

/

OK···[MENU]

:

   

:

1.  Press 

 , 

 , 

 or 

 to select the date and 

time, and press 

 or 

 to change the numerical 

values. 

2.  Press

 or 

 to select SET and then press 

MENU

 .

•  Be sure to set the date and time.

•  The date/time setting screen will close automatically if no 

operation is performed for about 15 seconds. The date 

and time can be set using DATE/TIME SETTING from the 

OPTION menu when the date/time setting screen disappears.

TIPS

•

Set the date in “Day/Month/Year” order.

•

Set the time on a 24-hour basis.

•

The clock is maintained by the internal battery.

•

If you already set the time but the date/time setting 

screen appears when the power is turned on, the 

internal battery may be exhausted. Please contact 

your local Sharp servicing dealer or service center for 

assistance with battery replacement.

•

Estimated service life of the internal battery: About 5 

years (depending on monitor operation)

•

The initial battery was inserted at the factory when the 

monitor was shipped, so it may run out of power before 

its expected operation life.