Tektronix MTM400 사용자 설명서

Appendix A: Network Installation 

 

 

MTM400 MPEG Transport Stream Monitor User Manual 

The IP set-up is now complete. Close the MS-DOS window. With the IP Address 
successfully set up, the network settings can be completed (refer to Resetting the 
IP Address using the User Interface, page A-4). 

The ARP command cannot be used if the unit already has an IP address - it will 
only work if the IP is 0.0.0.0. (Refer to Resetting the IP Address to Factory 
Default, page A-5 if the IP address is to be reset.) 

If the MTM400 is to be accessible by network name rather than IP address, the 
relationship between the IP address and the network name will need to be set up on 
a DNS (domain name server) server on the network. This is not the name set up in 
the Configuration screen. Contact your Network Administrator for help. 

When the IP address has been set up, if the MTM400 is to be accessed from a 
different net or subnet, the Gateway IP address and the Subnet Mask must be set 
up. Contact your Network Administrator for help. The Gateway IP address and the 
Subnet Mask values are set up in the Device Configuration Î Network 
Settings… dialog. The MTM400 must be restarted in order for the settings to take 
effect. 

It has been noted that where access to a remote MTM400 uses a number of 
internet/intranet links of varying speeds, the initial RUI download may be initiated 
successfully, but the process then ceases. The network speed is outside of the 
control of Tektronix, but it may be possible to alter some of the local network 
settings to alleviate the problem.