Pioneer PRO-101FD 사용자 설명서

En

When choosing the location for your panel, there are several factors to keep in mind. The installation site should 
be out of direct sunlight and have sufficient ventilation around the flat panel display to allow cooling. The diagram 
below is an example of a stand-mounted panel with proper ventilation.

Use the checklist below to judge possible installation sites.

For specific cautions and safety information, refer to “8.2 Physical Location & Temperature Considerations” and 
“8.8 Safety Precautions.”

This flat panel display is built for endurance but because of the technology, the panel must be handled with care. 
Use the handles attached to the rear of the flat panel display to lift the unit. To avoid flexing or twisting the unit, 
you need at least two people to lift and move the panel. Do not move the flat panel display by holding only a single 
handle or by dragging the panel by its handles.

Note: 

Do not use the handles to hang the flat panel display or as anchors to prevent the panel from slipping or 

tipping after it is mounted.

Sufficient ventilation

No danger of power overloads

Safe from excessive vibrations

Separate from other IR equipment

Away from air conditioners

Protected from hits or shocks

Free of moisture or dampness

Distance from heat sources

No danger of splashing water

Out of direct sunlight

Route cords and cables safely

Away from strong lighting sources

Over 
10 cm
(3 15/16 
inches)

Over 50 cm 
(19 11/16 inches)

(PRO-141FD)

(PRO-101FD)

PRO-141FD_PRO-101FD.book  Page 14  Monday, May 12, 2008  3:27 PM