Pioneer PRO-101FD 사용자 설명서

Use Other Equipment With Your Flat Panel Display

6.9.2

Assign a Baud Rate

This section describes how to enter the RS-232C transmission speed (baud rate) when controlling or adjusting
the panel using a PC. (Use this option only when making picture adjustments for a specific device(s) connected
to the RS-232C terminal.) The baud rate can be set to 1200bps, 2400bps, 4800bps, 9600bps, 19200bps or
38400bps. To enter a rate, follow the directions below.

1 ) Access

Serial Setting through the Control Setup menu.

2 ) Select

Baud Rate from the Serial Setting menu.

3 ) Select the desired rate from the submenu.

The factory default setting is 9600bps.

Note:

This setting applies to all input sources.

6.10 Select the Integrator Mode

Integrator Mode provides alternative options when using specific functions/settings and picture adjustment
menus.
Notes:

Integrator Mode is only available in English.
After entering the Integrator Mode, the following options on the Home Menu are reset to the factory
defaults:
• Picture

• Screen

After entering the Integrator Mode, the following options remain unchanged:

• Power Control

• Option

• Input Setup

• Control Setup

To switch to the Integrator Mode, follow the directions below.

1 ) Press INPUT to select the desired input.

2 ) Press DISPLAY to reveal current settings.

Status information on the selected input appears on screen.

1200bps
2400bps
4800bps
9600bps
19200bps
38400bps

Baud Rate

- - -

FULL
Standard

Component

INPUT2

PRO-141FD_PRO-101FD.book Page 70 Monday, May 12, 2008 3:27 PM