Fellowes 403054 사용자 설명서

Fellowes warrants all parts of the binder to be free of defects in material and workmanship 

for 2 years from the date of purchase by the original consumer. If any part is found to be 

defective during warranty period, your sale and exclusive remedy will be repair or replacement, 

at Fellowes’ option and expense, of the defective part. This warranty does not apply in 

cases of abuse, mishandling or unauthorised repair. Any implied warranty, including that of 

merchantability or fitness for particular purpose, is hereby limited in duration to the appropriate 

warranty period set forth above. In no event shall Fellowes be liable for any consequential 

damages attributable to this product. This warranty gives you specific legal rights. You may 

have other legal rights that vary from this warranty. The duration, terms and conditions of this 

warranty are valid worldwide, except where different limitations, restrictions or conditions may 

be required by local law. For more details or to obtain services under this warranty, please 

contact Fellowes or your dealer.

Wire binding is a secure binding system. Additional sheets cannot be 

added unless the document is disassembled and then re-bound.

The waste tray is located under the machine and is accessed from the 

right side. For best results empty the tray regularly.

Lower the punch handle to the horizontal position. Lower the lid. 

Punched holes are not central

Machine will not punch 

Punch holes are not parallel to edge

 
 
Partial holes

Damaged hole edges 

Waste tray leaks 

Sheets fall out of document

Edge guide not set

Blockage

Debris is stuck below dies

 
 
Sheets not correctly aligned to punch pattern

Possibly overloading the machine 

Waste tray is not correctly inserted or ‘burst 
feature’ has activated

Wire comb is not closed enough

Adjust edge guide until hole pattern is correct

Check waste tray in empty. Check for blockage to paper entry

Take stiff cardboard and slide into the paper entry. Move the 
cardboard sideways to release any stray clippings into the 
waste tray

Adjust edge guide and test punch scrap sheets until correct

Punch plastic covers with paper sheets. Reduce number of  
sheets being punched

Check waste tray is empty and ‘burst feature’ is closed 

Check closure of wire comb. Place into closing mechanism and 
improve binding closure.