NCR 5992 사용자 설명서
4-18
Operational Modes
Maintenance Mode
When power is applied to the 5992, it begins Power-up diagnostics. If
the status of all tests is “Passed,” a tone sounds. To enter Maintenance
Mode, immediately touch the stylus to the NCR logo at the upper right
corner of the screen.
the status of all tests is “Passed,” a tone sounds. To enter Maintenance
Mode, immediately touch the stylus to the NCR logo at the upper right
corner of the screen.
Note:
If you wait too long, the 5992 will enter normal mode and you
will have to power off and start over.
The Maintenance Mode displays permit you to select options that
modify the operation of the 5992. Instructions are displayed, and
options are selected with the touch of the stylus.
modify the operation of the 5992. Instructions are displayed, and
options are selected with the touch of the stylus.
The main menu displays the firmware and software identification
numbers plus the following choices:
numbers plus the following choices:
•
SETUP procedures to establish operating parameters
•
DIAGNOSTICS to verify operation
•
RUN to terminate Maintenance Mode and initiate Normal Mode of
operation
operation
•
LOAD APPLICATION to make the 5992 ready to receive a
download of the operating system
download of the operating system
The RUN option of the main menu terminates Maintenance Mode and
initiates Normal Mode operation.
initiates Normal Mode operation.
Performing a Setup
Enter SETUP from the Maintenance Mode menu by touching the stylus
to the SETUP selection. SETUP lets you do any of the following:
to the SETUP selection. SETUP lets you do any of the following:
•
Calibrate the digitizer
•
Adjust the screen contrast
•
Set the EIA-485 link address
•
Set the EIA-232 mode (manual or automatic)
•
Doodle (tests the stylus and digitizer)