Toshiba M30X 사용자 설명서
177
If Something Goes Wrong
Resolving a hardware conflict
5.375 x 8.375 ver 2.3
2
Click Stop xxxx, where xxxx is the identifier for your PC
Card.
Card.
The operating system displays a message that you may safely
remove the card.
remove the card.
3
Remove the card from the slot.
Never swap modules when the computer is in Hibernation or
Standby mode. This is known as “warm swapping” and is not
supported with this computer For more information on
Hibernation and Standby modes, see
Standby mode. This is known as “warm swapping” and is not
supported with this computer For more information on
Hibernation and Standby modes, see
The system does not recognize your PC Card or
PCMCIA socket controller.
PCMCIA socket controller.
1
Make sure the computer is not in Standby mode. For more
information, see
information, see
.
2
Turn off the computer.
3
Connect the AC adapter and power cord/cable.
4
Keep the computer plugged in for about three hours with
the power turned off.
the power turned off.
The problem may also be caused by a conflict with any
additional memory in your system.
additional memory in your system.
Removing a malfunctioning card and reinstalling it can
correct many problems. For more information, see
correct many problems. For more information, see
A PC Card error occurs.
Reinsert the card to make sure it is properly connected.
If the card is attached to an external device, check that the
connection is secure.
connection is secure.
Refer to the card’s documentation, which should contain a
troubleshooting section.
troubleshooting section.