Iomega 03798300 사용자 설명서
21
Installation
Guide
Connect an internal computer power supply
cable to your Zip
cable to your Zip
®
drive.
M NOTE:
If the computer does not have a spare power supply cable,
use the power Y-cable provided. Disconnect the power from the CD
drive or another device (do not disconnect the power to the hard drive)
and connect the power Y-cable. Connect the two extensions of the
power Y-cable to both the CD drive or other device and to the Zip
drive or another device (do not disconnect the power to the hard drive)
and connect the power Y-cable. Connect the two extensions of the
power Y-cable to both the CD drive or other device and to the Zip
®
Internal drive.
M
Zip Internal
drive
Power Supply Cable
from Computer
from Computer
CAUTION
Make sure the power supply cable is securely connected to
the Zip
®
drive.
M
Secure drive in drive bay.
Align the front of the Zip
®
drive with other drives installed in the computer.
If there is not a clear access to the drive bay mounting holes, refer to your
computer manual for additional instructions. Note that if the drive is held
in place securely by rails, you will not need to use the mounting screws.
computer manual for additional instructions. Note that if the drive is held
in place securely by rails, you will not need to use the mounting screws.
Drive Bay
Mounting Screws
Mounting Screws
CAUTION
Mounting screws must not extend into the Zip
®
Internal
drive farther than 4.0 mm (about 0.16 inch). Mounting screws that are
too long could damage the drive.
too long could damage the drive.
M
8
9