DCS 1.0x 사용자 설명서
dCS Verona User Manual
Manual for Software Issue 1.0x
dCS Ltd
September 2004
Manual filename: Verona Manual v1.0x.doc
Page 8
email: more@dcsltd.co.uk
English version
web-site: www.dcsltd.co.uk
S
TEP
-
BY
-S
TEP
G
UIDE
This section guides you through setting up the unit for basic operation. You may
find this useful if you have not used the Verona for a while.
find this useful if you have not used the Verona for a while.
Preliminaries
The Control Summary sheet details the menu structure and outlines the use of
the front panel controls. For more information, see the Menu section on page
the front panel controls. For more information, see the Menu section on page
For digital interfaces, use with cables designed for digital audio:
•
for Word Clock interfaces, use 75
Ω
coax cables fitted with BNC plugs.
•
for SPDIF RCA interfaces, use 75
Ω
coax cables fitted with RCA Phono
plugs.
do this:
Connect the power cable supplied to the Power inlet on the Verona rear panel,
plug the other end into a convenient power outlet. Set the power switch beside
the power inlet to the on position (I).
plug the other end into a convenient power outlet. Set the power switch beside
the power inlet to the on position (I).
IMPORTANT!
Please do not use an excessively thick power cable as this may damage the
power inlet connector. Such damage is not covered by the warranty.
power inlet connector. Such damage is not covered by the warranty.
do this:
Press the
Power
button and wait about 5 seconds while Verona configures
itself.
The display will show in sequence:
Verona
,
Testing
and either
44.1kHz
or
48kHz.
If the unit is likely to be set in an unfamiliar state, you can reset it as follows:
do this:
Press the
Menu
button once, then press the
Step Back
button so the display
shows
Factory
. Press the
Select
button and wait a second.
The unit will display
Defaults
. The
PWR
indicator and perhaps the
OK
indicator
will be lit, the others should be off.