Emerson PMPPC7448 사용자 설명서
Setup:
PmPPC7448 Circuit Board
2-7
Reset
The reset signals are routed to the CPLD, unless stated otherwise. See Chapter 7 for the
reset registers. The following sources can reset the PmPPC7448:
reset registers. The following sources can reset the PmPPC7448:
Power-on:
This causes a hard reset to the entire board, including the PCI interfaces.
Front panel:
This reset switch is accessible through a small hole in the front panel and causes a hard reset
to the entire board, including the PCI interfaces.
to the entire board, including the PCI interfaces.
Caution:
Use minimal force when pressing the front panel reset switch. Excessive force may damage
the switch.
the switch.
PCI RESET:
This causes a hard reset to the entire board, including the PCI interfaces.
COP HRESET:
This reset is activated by the common on-chip processor (COP) debugger interface via a
header located on the Development Mezzanine Card (DMC). It causes a hard reset to the
entire board, including the PCI interfaces.
header located on the Development Mezzanine Card (DMC). It causes a hard reset to the
entire board, including the PCI interfaces.
COP SRESET:
This reset is activated by the COP debugger interface and causes a soft reset to the Frees-
cale MPC7448 and a reset to Flash.
cale MPC7448 and a reset to Flash.
COP TRST:
This is routed directly to the MPC7448 TRST.
PMC TRST:
This is routed directly to the MV64460 TRST.
Software controlled:
The software controlled resets are described in the Reset Command register, Register
Map 7-2.
Map 7-2.
!