AMCC 9500S 사용자 설명서

Port Object Commands

77

Port Object Commands

Port Object Messages are commands that provide information and perform 
actions related to a specific disk, attached to a port, such as /c0/p0. You use 
port object commands for such tasks as seeing the status, model, or serial 
number of the drive. 

/cx/px show                                                      

/cx/px show attribute [attribute ...]  where attributes are:

capacity|firmware|identify (9550SX, 9590SE, 9650SE)|

lspeed (9550SX, 9590SE, 9650SE)|model|

ncq (9550SX, 9590SE, 9650SE)|serial|smart|status

/cx/px show all                                           

/cx/px remove [noscan][quiet] 

/cx/px set identify=on|off (9550SX, 9590SE, 9650SE)

/c

x

/p

x 

show

This command shows summary information about the specified disk attached 
to port /cx/px. Typical information looks like: 

//localhost> /c1/p5 show

Port   Status     Unit   Size        Blocks        Serial

---------------------------------------------------------

p5     OK         u0     149.05 GB   312581808     3JS0L9QW   

The above report indicates that port 5 of controller 1 is attached to one l disk 
with status OK participating in unit 0.

/c

x

/p

x

 show

 attribute

 [

attribute

 ...]

This command shows the current setting of the given attributes on the 
specified port or drive. One or many attributes can be requested. Specifying 
an invalid attribute will terminate the loop. Possible attributes are: capacity, 
firmware, identify (9550SX, 9590SE, and 9650SE only), lspeed (9550SX, 
9590SE, and 9650SE only), model, ncq (9550SX, 9590SE, and 9650SE only), 
serial, smart, and status.