Motorola MVME956AC 사용자 설명서

5-1

This chapter provides recommended procedures for the removal and 
replacement of MVME956AC chassis major assemblies. For 
identification and location of the assemblies and parts mentioned in these 
procedures, refer to the drawings and parts lists in 

. 

The removal/replacement procedures are organized and presented in the 
following order: 

❏

❏

 

❏

❏

(s)

❏

Motorola strongly recommends that you use an antistatic wrist strap and a 
conductive foam pad when installing or upgrading the system. Electronic 
components, such as disk drives, computer boards, and memory modules, 
can be extremely sensitive to ESD. After removing the component from 
the system or its protective wrapper, place the component flat on a 
grounded, static-free surface, and in the case of a board, component-side 
up. Do not slide the component over any surface.

If an ESD station is not available, you can avoid damage resulting from 
ESD by wearing an antistatic wrist strap (available at electronics stores) 
that is attached to an unpainted metal part of the system chassis.