Microsoft G7VP2 사용자 설명서

Hardware Installation

Connecting the USB Ports

As an option, one card-edge bracket mounted with two USB port

cables may be provided with the system board. The ends of the

cables are attached to a connector. Connect the USB cable

connector to J2 and J3 on the system board. The USB port cables

can be inserted only if pin 1 of the cable (red wire) is aligned with

pin 1 of J2 and J3. Pin 5 of J3 has been removed and the hole in

the USB cable connector, which corresponds to pin 5, has been

plugged to prevent incorrectly inserting the connector. Mount the

card-edge bracket to the system chassis.

2.9.8 IrDA Connector

The system board is equipped with an IrDA connector for wireless

connectivity between your computer and peripheral devices. Connect

your IrDA cable to connector J6 on the system board. Make sure

Onboard UART 2 Mode in the Integrated Peripherals setup of the

Award BIOS is set to the type of IrDA standard supported by your

IrDA peripheral/device.

You must have the proper drivers installed in your operating system

to use this connector. Refer to your operating systems manual or

documentation.

1
2

3
4
5

Function
IRTX
Ground
IRRX
IRR3
Vcc