Novatel OM-20000077 사용자 설명서

다운로드
페이지 87
Introduction
Chapter 1
SUPERSTAR II User Manual Rev 3
 15
Operating temperature range of -30
°C to +75°C
1PPS output aligned on GPS Time + 200 ns
1Hz measurement output aligned on GPS Time
Support for 62 predefined datums
Field-upgradeable firmware (stored in Flash memory) through the TTL serial port
Code and Carrier Phase tracking of L1 GPS frequency for increased accuracy
Retention of satellite almanac and ephemeris data in non-volatile memory for rapid time-to-first-
fix (TTFF) after power interruption
Very fast signal re-acquisition when signal masking (obstruction or vehicle attitude) occurs
Allows for warm start
1 Hz Position, Velocity and Time (PVT) output
Available Model Features
1
:
1 or 10 Hz carrier phase measurements (Message ID# 23, Measurement Block Data only works 
with these models)
Precise timing
5 Hz PVT output
RTCM DGPS Base
1.2
FlexPak-SSII
The FlexPak-SSII, see Figure 2, is a hardware interface between your equipment and the SUPERSTAR II GPS 
card. The Development Kit is an equipment set permitting easy evaluation of the receiver and includes the 
SUPERSTAR II GPS card in a FlexPak-SSII enclosure. It provides single-frequency positioning with two 
COM ports. A full description of this Development Kit and technical specifications of the FlexPak-SSII are 
provided in Appendix B, FlexPak-SSII Specifications, starting on Page 49.
 Figure 2: FlexPak-SSII Enclosure
The FlexPak-SSII offers the following features:
A shock and dust resistant enclosure
Waterproof to IEC 60529 standards IPX4 and IPX7
1.
Refer to Appendix A of the L1 GPS Firmware Reference Manual for models and their capabilities.