Texas Instruments TMS320DM647 사용자 설명서
www.ti.com
2.4.4
Deactivation (DCAB and DEAC)
DCAB
DDR_CLK
DDR_CLK
DDR_CLK
DDR_CS
DDR_CKE
DDR_RAS
DDR_WE
DDR_DQM[3:0]
DDR_CAS
DDR_BA[2:0]
DDR_A[13:11, 9:0]
DDR_A[10]
DEAC
DDR_CLK
DDR_CLK
DDR_CLK
DDR_CS
DDR_CKE
DDR_RAS
DDR_WE
DDR_DQM[3:0]
DDR_CAS
DDR_BA[2:0]
DDR_A[13:11, 9:0]
DDR_A[10]
Peripheral Architecture
The precharge all banks command (DCAB) is performed after a reset to the DDR2 memory controller or
following the initialization sequence. DDR2 SDRAMs also require this cycle prior to a refresh (REFR) and
mode set register commands (MRS and EMRS). During a DCAB command, DDR_A[10] is driven high to
ensure the deactivation of all banks.
following the initialization sequence. DDR2 SDRAMs also require this cycle prior to a refresh (REFR) and
mode set register commands (MRS and EMRS). During a DCAB command, DDR_A[10] is driven high to
ensure the deactivation of all banks.
shows the timing diagram for a DCAB command.
Figure 6. DCAB Command
The DEAC command closes a single bank of memory specified by the bank select signals.
shows
the timings diagram for a DEAC command.
Figure 7. DEAC Command
DSP DDR2 Memory Controller
16
SPRUEK5A – October 2007