Texas Instruments TSC2007EVM 사용자 설명서
www.ti.com
6
Kit Operation
6.1
TSC2007EVM-PDK Block Diagram
Kit Operation
Table 6. List of Jumpers
JUMPER
SHUNT POSITION
JUMPER DESCRIPTION
JMP1
2-3
Analog power select (default is +3.3VD)
JMP2
Closed
EEPROM address select. When installed and used with the USB-MODEVM, firmware for the
motherboard is executed from the EEPROM on the TSC2007EVM. This is the default mode.
motherboard is executed from the EEPROM on the TSC2007EVM. This is the default mode.
The following section provides information on using the TSC2007EVM-PDK, including setup, program
installation, and program usage.
installation, and program usage.
A block diagram of the TSC2007EVM-PDK is shown in
. The evaluation kit consists of two circuit
boards connected together. The motherboard is designated as the USB-MODEVM interface board; the
daughtercard is the TSC2007EVM described previously in this manual.
daughtercard is the TSC2007EVM described previously in this manual.
SLAU199 – March 2007
TSC2007EVM and TSC2007EVM-PDK User's Guide
5