Texas Instruments TSC2007EVM-PDK 사용자 설명서
www.ti.com
TAS1020B
USB 8052
microcontroller
USB
EVM Position 1
EVM Position 2
Control Interface
Audio Interface
TSC2007EVM
TSC2007
SPI, I2C
I2S, AC97
X+
X−
Y+
Y−
AUX
SDA
SCL
SCL
PENIRQ
6.2
Quick Start
Kit Operation
Figure 1. TSC2007EVM-PDK Block Diagram
The USB-MODEVM interface board is intended to be used in USB mode, where control of the installed
EVM is accomplished using the onboard USB controller device. However, provision is made for driving all
the data buses (I
EVM is accomplished using the onboard USB controller device. However, provision is made for driving all
the data buses (I
2
C, SPI™, and I
2
S/AC97) externally. The source of these signals is controlled by SW2 on
the USB-MODEVM.
Before installing the TSC2007EVM board on top of the USB-MODEVM board, check SW2-1, SW2-2, and
SW2-3 on the USB-MODEVM board to ensure that at least one of these three is OFF
SW2-3 on the USB-MODEVM board to ensure that at least one of these three is OFF
Ensure that the TSC2007EVM is installed on the USB-MODEVM interface board. The TSC2007EVM
should be installed in the topmost position, using J11, J12, and J13 on the USB-MODEVM.
should be installed in the topmost position, using J11, J12, and J13 on the USB-MODEVM.
6
TSC2007EVM and TSC2007EVM-PDK User's Guide
SLAU199 – March 2007