Texas Instruments SCAU020 사용자 설명서
www.ti.com
2
Signal Path and Control Circuitry
Signal Path and Control Circuitry
The CDCE421 can accept a 27MHz—38.33MHz frequency input from either an LVCMOS source (up to
3.3V) or a crystal in the same frequency range.
3.3V) or a crystal in the same frequency range.
The CDCE421EVM is divided into four blocks. The programming section and device power for each sector
can be enabled or disabled through individual switches provided for each block. For example, in order to
enable power and programming for Block A, the switch must be in the setting shown in
can be enabled or disabled through individual switches provided for each block. For example, in order to
enable power and programming for Block A, the switch must be in the setting shown in
. The
other blocks are enabled and disabled with the respective switches in the same manner.
The CDCE421 output frequency is always an integer multiple or integer divide of the input frequency, and
is determined through selection of VCO1 or VCO2 and the appropriate prescalar and output divider, based
on the
is determined through selection of VCO1 or VCO2 and the appropriate prescalar and output divider, based
on the
The loop filter selection affects the output frequency phase noise and should be considered in conjunction
with the type of input used.
with the type of input used.
In LVDS mode, the device can achieve up to 500MHz output. In LVPECL mode, the device can achieve
1175MHz output. The output signaling level and LVPECL termination are selectable through the software
interface.
1175MHz output. The output signaling level and LVPECL termination are selectable through the software
interface.
Figure 2. CDCE421EVM Programming Blocks
10.9MHz–1175MHz Low Phase Noise Clock Evaluation Board
6
SCAU020 – March 2007