Texas Instruments TVP5154EVM 사용자 설명서
www.ti.com
2
Board Level Description
2.1
Test Points and Jumpers
Board Level Description
The TVP5154EVM consists of the TVP5154EVM module and the encoder EVM module. A 4-row 120-pin
connector connects the boards. The block diagram of the EVM set is shown in
connector connects the boards. The block diagram of the EVM set is shown in
Figure 1. TVP5154EVM Block Diagram
The TVP5154EVM was designed with test points and jumpers to help in evaluation and troubleshooting.
Each jumper is set by default in its preferred state for the TVP5154EVM. There are test points for SCL,
SDA, 3.3 V, and 1.8 V. All digital video data for each decoder core are brought out to a dual-row header,
which allows easy hookup to test equipment. The I
Each jumper is set by default in its preferred state for the TVP5154EVM. There are test points for SCL,
SDA, 3.3 V, and 1.8 V. All digital video data for each decoder core are brought out to a dual-row header,
which allows easy hookup to test equipment. The I
2
C address selection is made with two shunt jumpers,
which are only read after a reset or at power up. The default address is 0xB8. If the address needs to be
changed, the TVP5154 must receive a reset.
changed, the TVP5154 must receive a reset.
Table 1. I
2
C Address Selection Jumpers
(I2CSEL1, JP9 and I2CSEL2, JP10)
JP9
JP10
I
2
C ADDRESS
2-3
2-3
0xB8
1-2
2-3
0xBA
2-3
1-2
0xBC
1-0
1-2
0xBE
Table 2. Power-Down-Mode Selection Jumper
(PDN, JP11)
PWDN
1-2
Normal operation
2-3
Power down
SLEU069A – February 2006 – Revised July 2006
TVP5154EVM User's Guide
7