IBM 61Y 사용자 설명서

다운로드
페이지 226
 146
Hardware Maintenance Manual: xSeries 250
 
 
No beep symptoms
Diagnostic panel LEDs
The system error LED is turned on when an error is detected.  If the system error LED 
is on, remove the cover and check the diagnostic panel LEDs. The following is a 
complete list of diagnostic panel LEDs followed by the FRU/Action for correcting the 
problem.
Note:
If a diagnostic panel LED is on and the information LED panel system error 
LED is off, there is probably an LED problem.  Run LED diagnostics.
Notes:
1.
To locate the LEDs on the processor board see “Processor board component 
locations” on page 55.
2.
Check the System Error Log for additional information before replacing a FRU.
3.
It may be necessary to view the system error log from a remote connection, such 
as MOST.
Repeating Short Beeps
1.
Keyboard
2.
I/O Legacy Board
One Long and One Short 
Beep
1.
Video adapter (if present)
2.
I/O Legacy Board
One Long and Two Short 
Beeps
1.
Video adapter (if present)
2.
I/O Legacy Board
Two Long and Two Short 
Beeps
1.
Video adapter
No Beep Symptom
FRU/Action
No beep and the system 
operates correctly.
1.
Diagnostic LED Panel
No Beeps occur after 
successfully completing 
POST
  (The Power-On 
Status is disabled.)
1.
Run Configuration/Setup, set the Start Options Power-On 
Status to enable.
2.
Diagnostic LED Panel
3.
I/O Legacy Board
No ac power 
(Power 
supply ac LED is off)
1.
Check the power cord.
2.
Power Supply (If two are installed, swap them to determine 
if one is defective.)
3.
Power Backplane
No beep and no video
1.
System will not power-
up
 (Power supply ac 
LED is on)
1.
Beep/Symptom
FRU/Action