Intel PXP43 사용자 설명서

 
 
 
                                                                                                                                                                                                                                                                                                                                                           

 
 
 

 

 
1.  After all connection is made, close your computer case cover. 

2.  Be sure all the switch are off, and check that the power supply input voltage is set to 

proper position, usually in-put voltage is 220V

∼240V or 110V∼120V depending on your 

country’s voltage used. 

3.  Connect the power supply cord into the power supply located on the back of your system 

case according to your system user’s manual. 

4.  Turn on your peripheral as following order: 

a.  Your monitor. 
b.  Other external peripheral (Printer, Scanner, External Modem etc…) 
c.  Your system power.    For ATX power supplies, you need to turn on the power supply 

and press the ATX power switch on the front side of the case. 

5.  The power LED on the front panel of the system case will light.  The LED on the 

monitor may light up or switch between orange and green after the system is on.    If it 
complies with green standards or if it is has a power standby feature.    The system will 
then run power-on test.  While the test are running, the BIOS will alarm beeps or 
additional message will appear on the screen. 

If you do not see any thing within 30 seconds from the time you turn on the power.    The 
system may have failed on power-on test. Recheck your jumper settings and connections 
or call your retailer for assistance. 

6.  During power-on, press <Delete> key to enter BIOS setup.    Follow the instructions in 

BIOS SETUP.   

7.  Power off your computer: You must first exit or shut down your operating system 

before switch off the power switch.    For ATX power supply, you can press ATX power 
switching after exiting or shutting down your operating system.    If you use Windows 9X, 
click  “Start” button, click “Shut down” and then click “Shut down the computer?” 
The power supply should turn off after windows shut down.