RoboteQ AX1500 사용자 설명서
Connecting Power and Motors to the Controller
28
AX1500 Motor Controller User’s Manual
Version 1.9b. June 1, 2007
Controller Power
The AX1500 uses a flexible power supply scheme that is best described in Figure 8. In this
diagram, it can be seen that the power for the Controller’s microcomputer is separate from
this of the motor drivers. The microcomputer circuit is connected to a DC/DC converter
which takes power from either the Power Control wire or the VMot input. The diode circuit
is designed to automatically select one power source over the other, letting through the
source that is higher than the other.
diagram, it can be seen that the power for the Controller’s microcomputer is separate from
this of the motor drivers. The microcomputer circuit is connected to a DC/DC converter
which takes power from either the Power Control wire or the VMot input. The diode circuit
is designed to automatically select one power source over the other, letting through the
source that is higher than the other.
FIGURE 7. Controller Rear View and Power Connector Tabs
VMot
Motor 2
Motor 1
M2+
M1+
M1-
VMot
M2-
3 x Gnd
Pwr
Ctrl
Ctrl
Note:
Both VMot terminals are
connected to each other in
the board and must be
wired to the same voltage.
Both VMot terminals are
connected to each other in
the board and must be
wired to the same voltage.