DFI PM12-EC 사용자 설명서

Hardware Installation

2.6.3 IDE Disk Drive Connector

The  mainboard  is  equipped  with  two  shrouded  PCI  IDE  headers
that  will  interface  four  Enhanced  IDE  (Integrated  Drive  Electronics)
disk drives. To prevent improper IDE cable installation, each shrouded
PCI  IDE  header  has  a  keying  mechanism. The  40-pin  connector  on
the  IDE  cable  can  be  placed  into  the  header  only  if  pin  1  of  the
connector  is  aligned  with  pin  1  of  the  header. You  can  enable  or
disable  the  onboard  primar y  or  secondary  IDE  controller  in  the
Integrated Peripherals submenu (“VIA OnChip IDE Device” field) of
the BIOS.

Connecting the IDE Disk Drive Cable

1. If you are connecting two IDE drives, install the 40-pin connector

of the IDE cable into the primary shrouded IDE header (IDE 1 -
J1). If you are adding a third or four th IDE device, install the 40-
pin connector of the other IDE cable into the secondary
shrouded IDE header (IDE 2 - J2).

2. Install the other 40-pin header connector(s) into the device with

the colored edge of the ribbon cable aligned with pin 1 of the
drive edge connector(s).

IDE 1

(J1)

IDE 2

(J2)