Dialogic M7324 사용자 설명서

To determine the current setting of a Memory Button, press 

Feature

 

then press the Memory Button you want to check. The display shows the name 
of the feature programmed. 

Memory Button 00 is automatically assigned as the Handsfree/mute key when 
Full Handsfree is set to Y [refer to 

, B. 5. (c) (4)]. Memory Button 01 

is automatically set as the Intercom key when the number of intercom keys is 
set to 1 [refer to 

, A. 2. (f)]. To assign Memory Button 03 to Transfer, 

press: 

Feature

Feature

Key 03

 

This section applies to the configuration of Nortel BCM, version 3.7 
and 4.0. Different versions of the Nortel BCM software may not 
function exactly as described here. 

There are several specific programming requirements that apply if using a 
Dialogic

® 

PBX Integration Board with the Nortel BCM. Some are optional 

features, whereas others are mandatory. The mandatory programming 
requirements allow the PBX Integration Board to work correctly. 

Following are the programming instructions for the BCM. Where possible, 
templates are used but some customization is required for each phone. 

To simulate a hunt group, configure the first phone’s “Forward no answer” 
and “Forward on busy” fields to ring the second phone. The second phone 
configures these fields to forward these unanswered calls to the third phone, 
and so forth. The last phone is configured to forward these unanswered calls 
to the first phone. To support external lines, a possible setup is to specify 
external lines on the first phone. These external lines can be configured as 
separate line appearances by specifying “Appearance & Ring”; up to two 
external lines can be supported in this manner. Alternatively, the external lines 
can appear on the intercom lamp by specifying “Ring Only.”