Emerson MVME7100 사용자 설명서

This chapter provides startup and safety instructions related to this product, hardware 
preparation instruction that includes default switch settings. System considerations and 
installation instructions for the baseboard, PMC, and transition module are also described in 
this chapter.

A fully implemented MVME7100 consists of the baseboard plus:

z

Two single-wide or one double-wide PCI Mezzanine Card (PMC) slot for added versatility.

z

One transition module for support of the mapped I/O from the MVME7100 baseboard to the 
P2 connector. 

z

Up to two optional XMCspan cards.

The following table lists the things you will need to do before you can use this board and tells 
you where to find the information you need to perform each step. Be sure to read this entire 
chapter, including all Caution and Warning notes, before you begin.

Unpack the hardware.

 

on page 30

Configure the hardware by setting jumpers 
on the board and RTM.

 

on page 36

 and 

 

on page 76

Install the MVME7216E transition module in 
the chassis.

 

on page 40

Install PMC module (if required).

 

on page 40

Install XMCspan module (if required).

XMCspan Installation and Use (6806800H03)

Install the MVME7100 in the chassis.

 

on page 43

Attach cabling and apply power.

 

on page 45

Install PIM on transition module (if required).

 

on page 79

Ensure that the firmware initializes the 
MVME7100

Chapter 6, MOTLoad Firmware

Initialize the board

Chapter 6, MOTLoad Firmware

Examine and/or change environmental 
parameters.

Program the board as needed for your 
applications.