ASUS P8H77-M LE 사용자 설명서

2-19

ASUS P8H77-M LE

CPU C1E [Auto]

Enables or disables the C1E support function. This item should be enabled in order to enable the 

Enhanced Halt State. Configuration options: [Auto] [Enabled] [Disabled]
CPU C3 Report [Auto]

Allows you to disable or enable the CPU C3 report to OS. Configuration options: [Auto] [Enabled] 

[Disabled]
CPU C6 Report [Auto]

Allows you to disable or enable the CPU C6 report to OS. Configuration options: [Auto] [Enabled]

Configuration options: [Auto] [Enabled] 

[Disabled]

Allows you to enable or disable the High Precision Event Timer. 

Configuration options: [Enabled] [Disabled]

Allows you to enable or disable the Intel(R) Rapid Start Technology. 

Configuration options: [Enabled] [Disabled]

ISCT Configuration [Disabled]

Allows you to enable or disable the ISCT configuration. Configuration options: [Enabled] [Disabled]

While entering Setup, the BIOS automatically detects the presence of SATA devices. The 

SATA Port items show Not Present if no SATA device is installed to the corresponding SATA 

port.

Allows you to set the SATA configuration.
[IDE] 

 Set to [IDE] when you want to use the Serial ATA hard disk drives as 

Parallel ATA physical storage devices.

[AHCI] 

 Set to [AHCI] when you want the SATA hard disk drives to use the AHCI 

(Advanced Host Controller Interface). The AHCI allows the onboard storage 

driver to enable advanced Serial ATA features that increases storage 

performance on random workloads by allowing the drive to internally 

optimize the order of commands.

[RAID] 

 Set to [RAID] when you want to create a RAID configuration from the SATA 

hard disk drives.

S.M.A.R.T. (Self-Monitoring, Analysis and Reporting Technology) is a monitor system. When 

read/write of your hard disk errors occur, this feature allows the hard disk to report warning 

messages during the POST. Configuration options: [Enabled] [Disabled]

This item only appears when you set the SATA Mode Selection item to [AHCI] or [RAID] 

and allows you to enable or disable the hot-plug support for each SATA port. Configuration 

options: [Enabled] [Disabled]