AMCC 9590SE-4ME 사용자 설명서
Unit Object Commands
www.3ware.com
57
/c
x
/u
x
show cache
This command shows the current write cache state of the specified unit.
Example:
//localhost> /c0/u0 show cache
/c0/u0 Cache State = on
/c
x
/u
x
show ignoreECC
This feature only applies to 9000 series controllers.
This command shows the current setting of the ignoreECC policy for the
specified unit.
specified unit.
Example:
//localhost> /c0/u0 show ignoreECC
/c0/u0 Ignore ECC policy = off
/c
x
/u
x
show volumes
This feature only applies to 9000 series controllers.
This command reports the number of volumes in the specified unit. The
number of volumes will normally be “1” unless the drive capacity exceeds
2TB and auto-carving is enabled.
number of volumes will normally be “1” unless the drive capacity exceeds
2TB and auto-carving is enabled.
/c
x
/u
x
show all
This command shows the current setting of all above attributes.
If the auto-carve policy was on at the time the unit was created and the unit is
over the carve size, multiple volumes were created and are displayed at the
end of the summary information.
over the carve size, multiple volumes were created and are displayed at the
end of the summary information.
Example:
//localhost> /c0/u1 show all
/c0/u1 status = OK
/c0/u1 is not rebuilding, its current state is OK
/c0/u1 is not verifying, its current state is OK
/c0/u1 is not initializing, its current state is OK
/c0/u1 volume(s) = 2
/c0/u1 name = 1234567
/c0/u1 serial number = C6CPR7JMF98DA8001DF0
Unit UnitType Status %RCmpl %VlmCmpl Port Stripe Size(GB)
-----------------------------------------------------------------
u1 RAID-0 OK - - - 64K 3578.40
u1-0 DISK OK - - p0 - 298.20
u1-1 DISK OK - - p1 - 298.20