Canon B822 사용자 설명서
5-2
Sending methods_______________________________
■ Direct sending (see below)
■ Memory sending (see p. 5-3)
■ Manual sending (see p. 5-4)
■ Memory sending (see p. 5-3)
■ Manual sending (see p. 5-4)
Dialing methods ________________________________
There are several methods of dialing the receiving party’s number, depending on how your fax is
set up.
set up.
■ Regular dialing
■ One-touch speed dialing (see p. 5-5)
■ Coded speed dialing (see p. 5-5)
■ Directory dialing (see p. 5-6)
■ UCanTalk (see p. 5-7)
■ One-touch speed dialing (see p. 5-5)
■ Coded speed dialing (see p. 5-5)
■ Directory dialing (see p. 5-6)
■ UCanTalk (see p. 5-7)
Sending documents
Direct sending__________________________________
1
Load the document face up into the document tray.
See Loading documents, p. 3-2.
You can set the scanning resolution and contrast (see p. 5-1).
You can set the scanning resolution and contrast (see p. 5-1).
2
Dial the receiving party’s fax number.
Use one of the dialing methods described in this chapter.
3
Press [Start/Copy] twice.
The fax begins sending.
TEL=
3456xxxx
• If an error occurs during sending, the fax beeps intermittently for a few seconds and an error
message appears on the LCD. If this happens, correct the error and then press [Stop], then try
sending the document again. See LCD messages, p. 9-14.
sending the document again. See LCD messages, p. 9-14.
• The fax automatically redials if the receiving party does not answer or if the line is busy. (You
can specify the number of times it redials; see AUTO REDIAL, p. 8-3.)