Premier Mounts CDM-600 사용자 설명서

CDM-600 Satellite Modem 

Revision 7 

ODU Operation 

MN/CDM600.IOM 

D–4 

 RED: ONLINE:ODU2   MODE:AUTO   SWITCH:N 
    TXSW:OK   RXSW:OK   5V:5.0   12V:12.0 
 
There are two modes that can be edited: 
 

•  AUTO  

•  MANUAL 

 
This is the indication of the current operating mode of the 1:1 ODU system. In Auto 
mode, when the Online ODU faults, the switchover is done automatically to replace the 
faulty unit. 
 
SWITCHover: either Yes or No (Default: No.) 
 
The Online unit is indicated to the left of the screen. The user may force a Switchover to 
the other unit. To do so, position the cursor to the Switch position. Press the [

↑] or [↓] 

key to select Yes and press ENTER 
 
NOTE: If the ODU Redundancy system is in AUTO mode, a ‘forced switch-over’ can 
only occur if the currently OFFLINE unit is fault-free. 
 
Additional information shown on this screen: 
 
Waveguide Switch status, both Tx and Rx: OK or FT (fault). 
 
Redundancy Controller Box voltages: 5V and 12V values. These can assist in trouble-
shooting system problems. 

 

 
Use the [

←] or [→]keys to select the menu option, then press ENTER.