Premier Mounts CDM-600 사용자 설명서

CDM-600 Satellite Modem 

Revision 7 

Installation 

MN/CDM600.IOM 

2–2  

If the CDM-600 is to be mounted in a rack, ensure that there is adequate clearance for 
ventilation, particularly at the sides. In rack systems where there is high heat dissipation, 
forced air cooling must be provided by top or bottom mounted fans or blowers. Under no 
circumstance should the highest internal rack temperature be allowed to exceed 50°C 
(122°F). 
 
 

 

The CDM-600 CANNOT have rack slides mounted to the side of the 
chassis - two cooling fans are mounted on the right-hand side of the unit. 
However, Comtech EF Data recommends that an alternate method of 
support within the rack be employed, such as rack shelves. If there is any 
doubt, please consult the Comtech EF Data Customer Support department. 

 
 
Optional rear-mounting installation bracket 
 
Install optional installation bracket (Figure 2-1) using mounting kit, KT/6228-2. 

 

2 

FP/6138-1 

Bracket, Rear Support  

4 

HW/10-32x1/2RK 

Bolt, #10 Rack 

2 

HW/10-32HEXNUT 

Nut, #10 Hex 

2 HW/10-32FLT 

Washer, 

#10 

Flat 

2 

HW/10-32X1/4 SHC 

Screw, Socket 10-32 x 1/4inch 

 
The tools required for this installation are a medium Phillips

 screwdriver, and a  

5/32-inch SAE Allen

 Wrench. 

 

Refer to the following Figure, then install the Modem rear support brackets as follows: 
 
a)  Install the rear support brackets onto the mounting rail of the rack. Fasten with the 

bracket bolts. 
 

b)  Mount the modem into the equipment rack ensuring that the socket heads engage into 

the modem slots of the rear support brackets. 
 

c)  Fasten the provided #10 socket head screws to the rear-side mounting slots on either 

side of the chassis modem and secure with #10 flat washers and #10 hex nuts.