Netgear N300 사용자 설명서

Modem Router Setup Preparation

You can set up your modem router with the NETGEAR Genie as described in 

on page 19, with the Setup Wizard as described in 

on page 22, or 

manually as described in 

on page 23. However, before you 

start the setup process, you need to have your ISP information and to make sure the laptops, 
PCs, and other devices in the network have the settings described here.

For a Macintosh or Linux system, you have to use manual setup.

Use Standard TCP/IP Properties for DHCP

If you set up your computer to use a static IP address, you have to change the settings back 
so that it uses Dynamic Host Configuration Protocol (DHCP). 

Replace an Existing Modem and Router

To replace an existing modem and router, disconnect them and set them aside before starting 
the modem router setup. 

Gather ISP Information

You need the following information to set up your modem router and to check that your 
Internet configuration is correct. Your Internet service provider (ISP) should have provided 
you with all the information needed to connect to the Internet. If you cannot locate this 
information, ask your ISP to provide it. When your modem router Internet connection is set 
up, you no longer need to launch the ISP’s login program on your computer to access the 
Internet. When you start an Internet application, your modem router automatically logs you in.

Active Internet service provided by a DSL account

The ISP configuration information for your DSL account

ISP login name and password

ISP Domain Name Server (DNS) addresses

Fixed or static IP address

Host and domain names

Depending on how your ISP set up your Internet account, you could need to know 
one or more of these settings for a manual setup:

Virtual path identifier (VPI) and virtual channel identifier (VCI) parameters

Multiplexing method

Host and domain names