Netgear FVS318N 사용자 설명서
Introduction
16
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
The front panel also contains three groups of status indicator light-emitting diodes (LEDs),
including Power and Test LEDs, LAN LEDs, and WAN LEDs, all of which are explained in
detail in the following table. Some LED explanation is provided on the front panel.
including Power and Test LEDs, LAN LEDs, and WAN LEDs, all of which are explained in
detail in the following table. Some LED explanation is provided on the front panel.
Figure 1.
The following table describes the function of each LED.
Table 1. LED descriptions
LED
Activity
Description
Power LED
On (green)
Power is supplied to the wireless VPN firewall.
Off
Power is not supplied to the wireless VPN firewall.
Test LED
On (amber) during
startup.
startup.
Test mode. The wireless VPN firewall is initializing. After approximately 2
minutes, when the wireless VPN firewall has completed its initialization, the
Test LED goes off.
minutes, when the wireless VPN firewall has completed its initialization, the
Test LED goes off.
On (amber) during
any other time
any other time
The initialization has failed, or a hardware failure has occurred.
Blinking (amber)
The wireless VPN firewall is writing to flash memory (during upgrading or
resetting to defaults).
resetting to defaults).
Off
The wireless VPN firewall has booted successfully.
Power
Test LED
DMZ LED
Left WAN LED
Right WAN LED
Active WAN LED
Wireless LED
LED
Left LAN LEDs
Right LAN LEDs
(green, one for each port)
(one for each port)
(green)