Netgear FVS318N 사용자 설명서

(Optional) Configure Dynamic DNS on the WAN port. If required, configure your fully 
qualified domain names: See 

on page 35.

(Optional) Configure the WAN options. If required, change the factory default MTU size, 
port speed, and MAC address of the wireless VPN firewall: See 

on page 50. These are advanced features, and you usually do not 

need to change the settings.

Tasks to Set Up an IPv6 Internet Connection to Your ISP



Configure the IPv6 WAN mode. Select the IPv4 / IPv6 mode to support both IPv4 and 
IPv6 traffic: See 

on page 38.

Configure the IPv6 Internet connection to your ISP. Connect to your ISP: See one of the 
following sections:

Configure the IPv6 tunnels. Enable 6to4 tunnels and configure ISATAP tunnels: See 

on page 46 and 

on page 47.

(Optional) Configure Stateless IP/ICMP Translation (SIIT). Enable IPv6 devices that do 
not have permanently assigned IPv4 addresses to communicate with IPv4-only devices: 
See 

on page 49.

(Optional) Configure the WAN options. If required, change the factory default MTU size, 
port speed, and MAC address of the wireless VPN firewall: See 

on page 50. These are advanced features, and you usually do not 

need to change the settings.

Configure the IPv4 Internet Connection and WAN Settings

To set up your wireless VPN firewall for secure IPv4 Internet connections, you need to 
determine the IPv4 WAN mode (see the next section) and then configure the IPv4 Internet 
connection to your ISP on the WAN port. The web management interface offers two 
connection configuration options, discussed in the following sections: