Netgear FVS318N 사용자 설명서

In the IKE SA Parameters section of the screen, locate the DPD fields, and complete the 
settings as explained the following table:

Click Apply to save your settings.

Configure NetBIOS Bridging with IPSec VPN

Windows networks use the Network Basic Input/Output System (NetBIOS) for several basic 
network services such as naming and neighborhood device discovery. Because VPN routers 
do not usually pass NetBIOS traffic, these network services do not function for hosts on 
opposite ends of a VPN connection. To solve this problem, you can configure the wireless 
VPN firewall to bridge NetBIOS traffic over the VPN tunnel. 

Enable Dead Peer 
Detection

Select the Yes radio button to enable DPD. When the wireless VPN firewall 
detects an IKE connection failure, it deletes the IPSec and IKE SA and forces a 
reestablishment of the connection. You need to specify the detection period in 
the Detection Period field and the maximum number of times that the wireless 
VPN firewall attempts to reconnect in the Reconnect after failure count field.

Detection Period

The period in seconds between consecutive

 

DPD R-U-THERE messages, which are sent only when the 
IPSec traffic is idle. The default setting is 10 seconds.

Reconnect after 
failure count

The maximum number of DPD failures before the wireless 
VPN firewall tears down the connection and then attempts 
to reconnect to the peer. The default setting is 3 failures.