Netgear FVS318N 사용자 설명서

Once you start restoring settings, do not interrupt the process. Do 
not try to go online, turn off the wireless VPN firewall, shut down 
the computer, or do anything else to the wireless VPN firewall until 
the settings have been fully restored.



Use one of the following two methods:

Using a sharp object, press and hold the factory default Reset button on the rear panel of 
the wireless VPN firewall (see 

on page 18) for about 8 seconds until the Test 

LED turns on and begins to blink (about 30 seconds). To restore the factory default 
settings when you do not know the administration password or IP address, you need to 
use the factory default Reset button method.

On the Settings Backup and Firmware Upgrade screen (see the previous figure), next to 
Revert to factory defaults settings, click the Default button, and confirm your selection.

The wireless VPN firewall reboots. If you use the software Default button, the Settings 
Backup and Firmware Upgrade screen might remain visible during the reboot process, or a 
status message with a counter might show the number of seconds left until the reboot 
process is complete. The reboot process takes about 165 seconds. (If you can see the unit: 
The reboot process is complete when the Test LED on the front panel goes off.)

After you reboot with factory default settings, the wireless VPN 

firewall’s password is password, and the LAN IP address is 
192.168.1.1.