Netgear FVS318N 사용자 설명서

Click Apply to save your settings.

Enabling routing and other event logs might generate a significant 

volume of log messages. NETGEAR recommends that you enable 
firewall logs for debugging purposes only.

How to Send Syslogs over a VPN Tunnel between Sites



At Site 1, set up a syslog server that is connected to Gateway 1.

Set up a VPN tunnel between Gateway 1 at Site 1 and Gateway 2 at Site 2.

Change the remote IP address in the VPN policy on Gateway 1 to the WAN IP address of 
Gateway 2.

Change the local IP address in the VPN policy on Gateway 2 to the WAN IP address of 
Gateway 2.

At Site 2, specify that Gateway 2 should send the syslogs to the syslog server at Site 1.

Do you want 
to enable 
syslog?

To enable the wireless VPN firewall to send logs to a specified syslog server, select the Yes 
radio button. Complete the fields that are shown on the right side of the screen.

 

To prevent the logs from being sent, select the No radio button, which is the default setting.

SysLog Server

The IP address or FQDN of the syslog server.

SysLog Severity

All the logs with a severity that is equal to and above the severity 
that you specify are logged on the specified syslog server. For 
example, if you select LOG_CRITICAL as the severity, then the 
logs with the severities LOG_CRITICAL, LOG_ALERT, and 
LOG_EMERG are logged. 

Select one of the following syslog severities from the drop-down 
list:

•  LOG DEBUG. Debug-level messages.

•  LOG INFO. Informational messages.

•  LOG NOTICE. There are normal but significant conditions.

•  LOG WARNING. There are warning conditions.

•  LOG ERROR. There are error conditions.

•  LOG CRITICAL. There are critical conditions.

•  LOG ALERT. An action has to be taken immediately.

•  LOG EMERG. The wireless VPN firewall is unusable.