Acclaim Lighting ACL7500 사용자 설명서

 - TABLETOp
All Models

ACCLAIM LECTERN - CONTROL pANEL
Model Shown: ACL-7500U1

1.  Set all Input Level Controls to minimum & Tones Controls to flat

(the

middle setting)

before turning your system on

2.  Plug lectern gooseneck microphone into the Lectern Mic Jack located on

the tabletop

3.  Plug reading light into the Reading Lamp Jack on control panel
4.  Switch POWER to ON, the BATTERY LED will light
5.  Slowly increase the Level Control for the input jacks used  

to the desired volume

6.  Adjust BASS & TREBLE controls to desired sound quality

LECTERN  

MICROPHONE 

JACK

LECTERN TOP

UHF WIRELESS RECEIVER

Available on selected models only 

(please see page 6 for instructions)

TONE CONTROLS

Bass & Treble

WIRED MICROPHONE 

LEVEL CONTROL

LECTERN MIC LEVEL 

CONTROL

POWER ON  

INDICATOR LIGHT

READING LAMP JACK

Remove cap to use

LINE IN LEVEL  

CONTROL

AUXILIARY MICROPHONE 

INPUT JACK – XLR

Balanced - low impedance mi-

crophones, powers condenser

mics

SPEAKER OUT 

OUTPUT JACK – 1/4” PHONE

Balanced - drives an unpowered

2 ohm speaker in addition to the

built-in speakers

CHARGE INDICATOR LIGHT

(please see page 3 for instructions)

BATTERY LEVEL INDICATOR LIGHT

Model Shown: ACL-7500U1

LINE IN

INPUT JACK – 1/4” PHONE

Jack may be combined w/ mic inputs for a composite output 

For playback of tape/CD player or other audio source

LINE OUT 

OUTPUT JACK – 1/4” PHONE

Balanced - provides combined  

output of all active system inputs  

Record presentation / connect to another

powered sound system

INTERNAL SPEAKER SWITCH

Turn internal lectern speaker out-

put on / off

BALANCED MICROPHONE 

OUTPUT JACK – XLR

Use to connect Acclaim to a

house system

Waste electrical and electronic products must not be disposed of with household

waste. Please recycle where facilities exist. Check with your Local Authority or

Retailer for recycling advice.