Acer LISHIN SLS0335A19A54LF 사용자 설명서

Chapter 2

37

Set Supervisor/User Password

If password on boot is required, the password must be set otherwise it cannot be enabled.

The formats of the password are as follows:

Length           No more than 8 characters

Characters 0-9,A-Z (not case sensitive)

While these fields are highlighted and press “Enter”,  a window similar to the following is shown: 

If there is an old password then setup will prompt with the following window instead and a current password 
will be required to be entered at first: 

Set HDD Password

When shown as [Locked], the hard drive 
password currently can not be changed 
or disabled.
To change or disable it, turn off the 
system and enter Setup immediately after 
turning it back on.
Press [Enter] to input change, or disable 
hard drive password.

Password on boot

Defines whether a password is required 
or not while the events defined in this 
group happened. The following sub-
options are all requires the Supervisor 
password for changes and should be 
grayed out if the user password was used 
to enter setup. 
Allows the user to specify whether or not 
a password is required to boot.  

Disabled 
Enabled

     Set SupervisorPassword 

Enter New Password          [                          ] 

Confirm New Password      [                          ] 

Set Supervisor Password 

Enter current password      [                          ] 

Enter New Password          [                          ] 

Confirm New Password      [                          ]