Fujitsu 200 사용자 설명서

3. Remove the protective coating from the adhesive side of the new screen protector 

first. 

4. Apply the screen protector to the display screen surface. When doing so, orient 

the screen protector with the adhesive side of the screen protector facing the 
display screen and the notched corner of the screen protector toward the lower 
left corner of the display screen. 

5. Remove the protective plastic cover from the face of the screen protector.

6. Apply pressure to the screen protector with your finger using a continuous 

wiping motion along the edges. The adhesive sets completely within 48 hours. To 
ensure a good seal between the screen protector and the display, do not lift the 
screen protector from the display once it has been applied. 

7. Clean any residue left behind by the protective coating from the exposed surface 

of the screen protector by wiping gently with a soft cotton cloth dampened with 
denatured alcohol. Wipe the screen protector with a soft dry cloth to remove any 
low-tack adhesive; this will help to prevent the pen tip from squeaking.

The screen protector is now installed. 

Storing the PenCentra 200

5

Store the PenCentra 200 pen tablet in Suspended state with a fully charged battery 
pack installed. The PenCentra 200 battery pack always provides power to some 
system components, even when the system is in the Suspended state. If you plan to 
store the system with the battery pack removed, be sure to save any active data prior 
to storing; failure to do so could result in lost data. 

• Cleaning the screen surface with denatured alcohol may 

result in streaking. If streaking occurs, buff the screen 
surface lightly with a soft, dry cloth.

• The PenCentra 200 pen tablet is not waterproof. Do not 

pour liquids on the system or wash it with a soaked cloth.