Epson EL 486UC 사용자 설명서

Once the connectors reach the slot, push the card in firmly

(but carefully) to insert it fully. You should feel the card fit

into place. If it does not go in smoothly, do not force it; pull

the card all the way out and try again.

6. Secure the end of the card to the computer with the retaining

screw.

You may need to remove an option card installed in your

computer to access components on the main system board-to

change a jumper setting, for example. You may also want to

remove a card if you no longer need it. Refer to the option card

illustration on page 3-16 and follow these steps:

1.

Remove the retaining screw securing the option card to the

computer. Then pull the card straight out of the slot.

2. Set the card aside with the component side facing up

You may need to remove the option card connector board to

replace the microprocessor installed on your system board.

Follow these steps:

1. Remove any option cards from the connector board (see the

section above).

3-17