Texas Instruments 51X 사용자 설명서
3. Release the Keyboard by pulling the keyboard release tabs forward
(tabs are located underneath the Ctrl and right arrow keys).
4. Disengage the Keyboard using a straight blade screwdriver and gently
lifting up along the front edge of the keyboard.
5. Using the back edge of the keyboard as a hinge, lift the front edge of
the keyboard up and lay it against the display.
6. Insert the edge of the DIMM Board into the lower connector (refer to
Figure 2-1). Use a rocking motion to fully insert the module. Push
downward on each side of the DIMM module until it snaps in place.
downward on each side of the DIMM module until it snaps in place.
7.
Repeat the procedure in Step 6 (upper connector) to install the second
DIMM module.
DIMM module.
8.
Replace the keyboard assembly and any other components removed in
Step 1.
Step 1.
This completes the expansion memory module installation procedure.
1
Slide Keyboard Release
Tabs toward front of
notebook.
Tabs toward front of
notebook.
Using a small
flat blade screwdriver,
gently pry keyboard up
along the front edge.
flat blade screwdriver,
gently pry keyboard up
along the front edge.
2
Tilt the keyboard back
against the display
against the display
Insert the SIMM modules
into the two Main Board
memory connectors
into the two Main Board
memory connectors
Figure 2-1 Installing Additional Memory
2-2 Installation